What are the requirements for the automatic locking screw machine? We know that the automatic locking screw machine application has been widely used, not only high efficiency, but also low cost, then what are the requirements for screws in the use of automatic locking screw machine, including screw specifications, length and so on. Next, I will analyze it for everyone:

One: The automatic locking screw machine has the following requirements for screws:

1, screw length and specifications.

The total length of the screw must be greater than 1.2mm above the screw cap, and the screw hole depth should not exceed 40mm. When working, be sure to check for obstacles within 10mm of the screw hole position, because the obstacles will definitely affect the operation in production. In addition, the surface of the screw hole must be a slope with a plane alive of less than 30 degrees.

2, whether with a gasket.

If the screw has a gasket and the gasket is larger than the screw cap, then the diameter of the gasket should be used, so that it will not be reversed in the feeding tube. If the screw does not reach the total length of the screw larger than 1.2MM of the screw cap, then the feeding method must adopt adsorption or other means.

3. The thread of the screw.

 The thread of the screw is different. There is a triangular self-tapping locking screw. It has the same pitch as the metric thread, but the angle is a triangle. There are two parameters of D and C values to control the locking. The locking function can be achieved.